A gloved fingertip pressing a small bubble under tint film on a dark car window
Window film

What to Do If Window Film Bubbles

A bubble under new window film is a pocket of trapped air or water. Small water bubbles often disappear as the film cures, while air bubbles need to be dealt with at install. Note where the bubbles are and how many, watch them through the cure period and ask the shop that installed the film.

What causes bubbles under window film?

  • Trapped water: small water pockets can show until the film cures.
  • Trapped air: air bubbles need to be dealt with at install.
  • Contamination: dust, hair, grit or residue under the film shows as specks or bumps.
  • An unseated edge: edge lifting can come from poor prep, contamination or an edge that was not seated.
Gloved hand pressing a hard card across a wet car window to work out a bubble

How do I tell what I am looking at?

A shop can learn a lot by looking at the same spot twice. Photograph each area in the same light at pickup and again at the re-check, so you can tell whether small pockets are shrinking. Look from different angles and from both sides of the glass, since some marks are on the glass and some are under the film. Customers should not press or poke at bubbles, because that can lift an edge or crease the film. Bring the vehicle back to the shop and show them.

Comparison
What you seeWhat it can beWhat to do
Haze or small water pockets in new filmMoisture still under the filmWatch through the cure period and follow the installer's guidance
A bubble of airAir trapped at installTell the installer
Specks or bumpsContamination under the filmNote where and tell the installer
An edge rising from the glassEdge liftingTell the installer
Film lifting, bubbling or peelingDelamination, when layers separate from each other or from the glassTell the installer

How long should I wait?

Follow the installer's guidance on how long film takes to cure. Do not roll the windows down early; see the answer on how long to wait.

A light blue sedan parked just outside the open roll-up door with all windows up, daylight on the filmed glass.

Who do I contact?

Contact the shop that installed the film. Glacier supplies shops and does not sell to drivers or homeowners. Shops can read the answer on handling a complaint about a new tint job.

In this guide
  1. What causes bubbles under window film?
  2. How do I tell what I am looking at?
  3. How long should I wait?
  4. Who do I contact?

Quick answers

What causes bubbles under window film?

A bubble is a pocket of trapped air or water under installed film. Contamination such as dust, hair or grit can also show as specks or bumps.

Do water bubbles go away?

Small water bubbles often disappear as the film cures. Follow the installer's guidance on how long to wait.

Do air bubbles go away?

Air bubbles need to be dealt with at install. Tell the installer where they are.

What is haze under new film?

Haze is a cloudy look caused by moisture trapped under freshly installed film. It usually clears as the film cures.

What are specks or bumps under film?

They are contamination, meaning dust, hair, grit or residue trapped under the film during install.

What is edge lifting?

Edge lifting is a film edge rising from the glass after install. Common causes are poor prep, contamination or an edge that was not seated.

What is delamination?

Delamination is when a film's layers separate from each other or from the glass. It shows up as lifting, bubbling or peeling.

Who should I call about bubbles?

The shop that installed the film. Glacier supplies shops, not drivers or homeowners.

Need film or tools for your shop? Apply for a wholesale account.